Setting up a Customer Display for Octopos is a 3 part process:
Unbox and Mount the CDS on stand
Connect to Wifi.
Configure IP address in Octopos
Unbox the Components
Begin by unboxing the Samsung tablet and the extended USB to Type-C cable.
Verify that you have the following items:
One customer display tablet
One DC Powered Hub
One extended Type-C charging cable
Connect the Cable
Connect the USB end of the charging cable to the DC power hub. Ensure you use the power connection on the hub, not the programmable connection.
Connect the Type-C end of the cable to the customer display tablet.
Install the Plastic Clip
Flip the tablet over to expose the back.
Locate the black plastic clip provided in the package.
Remove the top red layer from the double-sided tape from the back of the black clip.
Position the clip in the center of the tablet and press firmly to secure it in place.
Connect the Tablet to the Stand
The stand has an "X" shaped slot for the customer display (CDS).
Mount the tablet's CDS bracket onto the stand by placing it into the "X" slot.
Rotate the CDS to clip it securely onto the stand.
The Customer display should then look like this once fully installed.
Additional Notes
Each tablet is pre-configured and tested by the Octopos team.
Refer to the provided reference image to confirm proper setup.
Once you have successfully installed your customer display on the stand, you need to connect it to Wi-Fi. Follow the next steps by clicking here.